Specification:
Project name: Windshield Repair Kit
Scope of application: most automobile
Product color: black
Product material: ABS, PP, silicone

Instruction:
1. Clean up the damage
2. Push the vacuum piston to the bottom.
3. Screw the tubing into the vacuum.
4. Add 1-3 drops of repair fluid to the damaged hole depending on the degree of damage. (The repair process needs to be in a wireless environment)
5. Place the vacuum suction cup at the center of the damage.
6.Pull the vacuum piston to the first slot and lock it to keep it in the pressure state.
7. Exhaust the second slot - pull the syringe piston to the second slot and lock it to maintain greater pressure for exhaust.
8. Wait for exhaust - wait 3-5 minutes for exhaust and observe whether the air in the damaged area is completely exhausted. If not, repeat steps 4, 5, and 6.
9. Remove the exhaust pump - please confirm that the repair of the damaged part is effective before curing. (The curing process is irreversible)
10. Drop the repair fluid - after the exhaust is completed, drop 1-2 drops of the repair fluid on the damaged area.
11. Place the curing film - Place the curing film to ensure there are no small bubbles in the middle
12. UV lamp curing - place the UV lamp on the curing film, connect the Type-C power supply device, and wait for 5-10
minute.
13. Remove the cured film - remove the cured film after confirming curing.
14. Clean up the residual glue - use a cutter to clean the glue after tearing off the cured film.
15. Repair completed - depending on the damage, the repair effect can reach 90-95% of the original. (Please note that the repair process is irreversible)

Product List:
Vacuumer *1
Adapter *1
Nozzle *1
Repair Fluid *1
Square Cured Film *5
Instruction *1
Cutter *1
Picking Needle *1


Notes:
Due to different lighting and screen settings, the product color may be slightly different from the picture.
Due to the difference in manual measurement, please allow a 1-3cm difference in size.